Difference between revisions of "Multicast Over DMVPN"

Latest revision as of 21:35, 7 April 2015

Once you've got your DMVPN up and running, as shown in the DMVPN article, you can enable multicast and PIM.

You just need to know the IP address of your rendezvous point (RP). Then you can roll this out to your hub(s).

ip multicast-routing
!
interface Tunnel0
 description DMVPN
 ip pim dr-priority 20
 ip pim sparse-mode
!
ip pim rp-address 10.16.10.251

The spokes get the same configuration, minus the dr-priority line.

Revision as of 22:47, 6 April 2015 (view source) Casey (talk \| contribs) (Created page with "Once you've got your DMVPN up and running, as shown in DMVPN, you can enable multicast and PIM. You just need to know the IP address of your rendezvous point (RP). The...")		Latest revision as of 21:35, 7 April 2015 (view source) Casey (talk \| contribs)
Line 1:		Line 1:
−	Once you've got your DMVPN up and running, as shown in [[DMVPN]], you can enable multicast and PIM.	+	Once you've got your DMVPN up and running, as shown in the [[DMVPN]] article, you can enable multicast and PIM.

	You just need to know the IP address of your rendezvous point (RP). Then you can roll this out to your hub(s).		You just need to know the IP address of your rendezvous point (RP). Then you can roll this out to your hub(s).